Running Vista 64, SW 2009 sp2 (just installed, however theissue I will describe occurred previously in sp1 and sp0.
Using an nvidia Quadro FX570 with 175.51 drivers.
Most times, when I'm in part or assembly mode, if I select a faceor edge, my display will not actually highlight what I've selectedunless I zoom in or out (via mouse wheel or spacepilot). SometimesI have to do a great deal of zooming/panning/rotating beforewhatever I've selected will actually highlight.
Searching through these forums, I've not found anyone with exactlythe issues I'm having, but I have tried customizing my 3d settingsper a few other posts with no improvement.
Besides this issue I have no other problems with SW graphics,performance-related or other (besides the fact it's a relativelyweak card when I have a large assembly).
Anyone ever experienced this? I think this may be strictly avista-related issue, but can't recall.SolidworksAdministration
Using an nvidia Quadro FX570 with 175.51 drivers.
Most times, when I'm in part or assembly mode, if I select a faceor edge, my display will not actually highlight what I've selectedunless I zoom in or out (via mouse wheel or spacepilot). SometimesI have to do a great deal of zooming/panning/rotating beforewhatever I've selected will actually highlight.
Searching through these forums, I've not found anyone with exactlythe issues I'm having, but I have tried customizing my 3d settingsper a few other posts with no improvement.
Besides this issue I have no other problems with SW graphics,performance-related or other (besides the fact it's a relativelyweak card when I have a large assembly).
Anyone ever experienced this? I think this may be strictly avista-related issue, but can't recall.SolidworksAdministration
