When using a section view of a U shaped piece of sheetmetalwith an angled end cap I want to show just the face of the sectionit self. Normaly when I do this I use the Partial Section andDisplay only cut faces options. On the part I am working on now theend cap will not disapere completely. I have tried using thesection depth setting and pushing it out past the end of the partand still no luck. The part is an assembly with a PEM in it and ifyou go back to the part itself you can make the section work butnot with the assembly. Any sugestions??? I tried to attach a PDF ofa screan shot but was not able to.SolidworksDrawings And Detailing