I routinely section through round barrels. Sometimes it ishard tosee if the section line I am drawing is going through thecenter ofthe barrel. I know that other programs allow me to hoverthepointer over the center point and then when I move the cursor upitshows a dotted line indicating that I am in line with thecenter.Very much like SW does when I am creating a sketch in apartfile.
Is this some option that I mistakenly changed or does SW notdothis ?
Any help is appreciated.
DanSolidworksDrawings And Detailing







Is this some option that I mistakenly changed or does SW notdothis ?
Any help is appreciated.
DanSolidworksDrawings And Detailing