One of my coworkers upgraded to SW2008, I'm wonering if Ishould wait.
We do alot of sheel metal parts.
When we make a base flange and use the bend allowance table that wecreated,
The bend table comes up on the screen goes through it's processthen closes.
After this the screen and all the graphics are fragmented includingthe toolbars etc. etc. SW2007 did not do this.
If you minimize SW08 and them maximize again it's fine
His Machine is Dell 390 Duel Core 2400 mghz 2 gig ram w/ Quadro1500.
Installed the SW2008 driver off the SW web site, no change, triedthe latest driver off the Nvidia web site, no change
Is there and option to check off that will stop the bend allowencefrom popping up,
we don't need to see it.
Or is there something else we should do.
Is this a video card issue or driver issue??
SolidworksAdministration
We do alot of sheel metal parts.
When we make a base flange and use the bend allowance table that wecreated,
The bend table comes up on the screen goes through it's processthen closes.
After this the screen and all the graphics are fragmented includingthe toolbars etc. etc. SW2007 did not do this.
If you minimize SW08 and them maximize again it's fine
His Machine is Dell 390 Duel Core 2400 mghz 2 gig ram w/ Quadro1500.
Installed the SW2008 driver off the SW web site, no change, triedthe latest driver off the Nvidia web site, no change
Is there and option to check off that will stop the bend allowencefrom popping up,
we don't need to see it.
Or is there something else we should do.
Is this a video card issue or driver issue??
SolidworksAdministration
