Hi All,
Any help would help. Below is where I'm at.
1st - I open an assembly.
2nd - I select a part for editing
3rd - I execute screen capture.
4th - I can't paste the image into a Word document.
Note- If I'm not in edit part mode then I can paste the screencaptured image.
What gives?
Thanks.
SolidworksGeneral







Any help would help. Below is where I'm at.
1st - I open an assembly.
2nd - I select a part for editing
3rd - I execute screen capture.
4th - I can't paste the image into a Word document.
Note- If I'm not in edit part mode then I can paste the screencaptured image.
What gives?
Thanks.
SolidworksGeneral