I have been setting a up a "render room" for our models. Theplan is to be able to change out the wire decks as I need them andsay GO. The renders then would be consistent and reproducible. Theproblem I am running into is that to get a decent render in PW , mySW lighting is way to bright.
Also I have apprently added all the spot lights I am allowed. Theshelf beam is actually supposed to be blue like in the SW portion,but it renders white with the spraypaint texture. The wire deck isa patterned from a scan I made of our typical powdercoating.
I am attaching a picture of a what I see with right side of thescreen rendered, and the rest as it appears in SW.
I could really use some help here, because I the renderings used tobe so easy. They were only the decking assembly with a shelf beamadded. I had to build them every time for each project. I washoping this would help me out.
Any ideas anyone?
SolidworksPhotoworks
Also I have apprently added all the spot lights I am allowed. Theshelf beam is actually supposed to be blue like in the SW portion,but it renders white with the spraypaint texture. The wire deck isa patterned from a scan I made of our typical powdercoating.
I am attaching a picture of a what I see with right side of thescreen rendered, and the rest as it appears in SW.
I could really use some help here, because I the renderings used tobe so easy. They were only the decking assembly with a shelf beamadded. I had to build them every time for each project. I washoping this would help me out.
Any ideas anyone?
SolidworksPhotoworks