I want to break up a drawing into sections, printing eachsection at full scale.
Each section is like a square on a checker board. I want to printeach section on its own sheet of paper. Then, I want to assemblethe sheets into a full-scale drawing of the part. This drawing canthen be used as a template for burning holes, etc.
I can't find a way to do this using the API. I see how to set thescale, but I don't see how to set the location on the SW sheetwhich will be at the origin (say, lower left corner) of the printedsheet.
Any ideas?
SolidworksApi macros
Each section is like a square on a checker board. I want to printeach section on its own sheet of paper. Then, I want to assemblethe sheets into a full-scale drawing of the part. This drawing canthen be used as a template for burning holes, etc.
I can't find a way to do this using the API. I see how to set thescale, but I don't see how to set the location on the SW sheetwhich will be at the origin (say, lower left corner) of the printedsheet.
Any ideas?
SolidworksApi macros