I have noticed this bug in 2008 (it didn't occur in 2006 or2007).
I place a hole...normally when I do this I use an equation, so thatif I change the width or length of the part/plate, the hole remainsin the correct position.
1) Place the point.
2) Add a horizontal dimension using an equation
Then, I can't do anything else unless I select the hole definitiontab and then switch back to the position tab. Once I flip from onetab and then back, I can place my next dimension, which is usuallythe vertical dimension which is also an equation.
Once I am done placing dimensions using equations and flipping tabsafter each placement, I can not complete the hole without doinganother tab flip.
Then, the hole will go in just fine.
This happens every time, so it is a reproducable error.
Just wondering if anyone else has noticed this.
Thanks,
Elise Moss
www.mossdesigns.comSolidworksParts And Features
I place a hole...normally when I do this I use an equation, so thatif I change the width or length of the part/plate, the hole remainsin the correct position.
1) Place the point.
2) Add a horizontal dimension using an equation
Then, I can't do anything else unless I select the hole definitiontab and then switch back to the position tab. Once I flip from onetab and then back, I can place my next dimension, which is usuallythe vertical dimension which is also an equation.
Once I am done placing dimensions using equations and flipping tabsafter each placement, I can not complete the hole without doinganother tab flip.
Then, the hole will go in just fine.
This happens every time, so it is a reproducable error.
Just wondering if anyone else has noticed this.
Thanks,
Elise Moss
www.mossdesigns.comSolidworksParts And Features