This new "PDMWorks" interface is very frustrating.
In SW2006, when you opened an assembly in SW Explorer, the entireassembly tree was shown, indented so you could tell what wasreferenced.
Now it appears that there is only a windows directory structure inthe left column, and no way to select what is referenced in sidethe assembly. In order to tell what is being referenced, you mustgo to the right side, but you can not select the referenced partsto modify their properties.
Is there some way to make the left column act like SW2006?
Mike.
SolidworksSolidworks Explorer
In SW2006, when you opened an assembly in SW Explorer, the entireassembly tree was shown, indented so you could tell what wasreferenced.
Now it appears that there is only a windows directory structure inthe left column, and no way to select what is referenced in sidethe assembly. In order to tell what is being referenced, you mustgo to the right side, but you can not select the referenced partsto modify their properties.
Is there some way to make the left column act like SW2006?
Mike.
SolidworksSolidworks Explorer
