I'm getting close to going live with EPDM. Doing a lot of thefinal testing and procedures as required. I noticed that if I usethe Pack & Go feature inside of SolidWorks that I can put theassembly and all the part models in a folder on my desktop with theadded prefix or suffix in the new folder. The problems begin when Iopen the "New" assembly with the added prefix.
1st The file is read only even though it was never checked into thevault.
2nd All the parts in the assembly are still looking at the originalfiles not the new ones with the added prefix or suffix.
this is the same for 2008 SP4.0 or 2009 SP2.0
Is this something that I have setup wrong or a bug?SolidworksSolidworks Pdm enterprise Pdm
1st The file is read only even though it was never checked into thevault.
2nd All the parts in the assembly are still looking at the originalfiles not the new ones with the added prefix or suffix.
this is the same for 2008 SP4.0 or 2009 SP2.0
Is this something that I have setup wrong or a bug?SolidworksSolidworks Pdm enterprise Pdm
