origin of drawing view related to origin of model in the veiw

I created a view in a drawing using the *Top view of themodel.
I need to draw a section line from the model origin.
I used 0,0 for the start of the line but this is slightly off theorigin of the model.
I would think that the view created by using *Top would have tomake the model origin the sketch origin. That doesn't seem to bethe case. I just need to know if the origin of the drawing viewsketch should be the origin of the model it holds. If not then whatis the api steps to getting the sketch point that represents themodel origin?SolidworksApi macros