Hi,
could anyone tell me what could be wrong?
When I try to start a route and select a pipe a message appears 'Novalid config could be found for this pipe'. Now I understand thatthe connection point value must tie in with the nominal diameter ofthe pipe, but this shouldn't be a probelm because I am using thesample parts from the 2007 Routing whats new file. I am editing thesample Route assembly which contains flanges, elbows and obviouslypipes, but when I even try to start a route with the components inthe assembly I still get the No config. found message!
How can this be because the parts obviously have matchingconfigurations because they already make up the route assembly thatI'm editing? Frustrating! Please can anyone help?
Best Regards
AdrianSolidworksRouting
could anyone tell me what could be wrong?
When I try to start a route and select a pipe a message appears 'Novalid config could be found for this pipe'. Now I understand thatthe connection point value must tie in with the nominal diameter ofthe pipe, but this shouldn't be a probelm because I am using thesample parts from the 2007 Routing whats new file. I am editing thesample Route assembly which contains flanges, elbows and obviouslypipes, but when I even try to start a route with the components inthe assembly I still get the No config. found message!
How can this be because the parts obviously have matchingconfigurations because they already make up the route assembly thatI'm editing? Frustrating! Please can anyone help?
Best Regards
AdrianSolidworksRouting
