I see My Forum Profile settings have been reset.
Not sure what caused this. The only change I see is a new category,Plastics and Mold Design.
Seems like a bug in the forum software if our settings are resetjust because a new category was added.
[rant on]
Speaking of forums, the 2 year anniversary of this "revised" forumwill be at the end of November. It's no different today than it wasat its introduction. Although some minor glitches were addressednothing groundbreaking has occurred.
The old forum software could thread messages far superior to whatwe are using today! To me, following threads is what a forum is allabout. I really miss that functionality!!!
Why can't we get an option to use a news reader for these forums.
IMHO, Autodesk has a great setup for dual functionality forums(nntp & http).
[rant off]SolidworksGeneral
Not sure what caused this. The only change I see is a new category,Plastics and Mold Design.
Seems like a bug in the forum software if our settings are resetjust because a new category was added.
[rant on]
Speaking of forums, the 2 year anniversary of this "revised" forumwill be at the end of November. It's no different today than it wasat its introduction. Although some minor glitches were addressednothing groundbreaking has occurred.
The old forum software could thread messages far superior to whatwe are using today! To me, following threads is what a forum is allabout. I really miss that functionality!!!
Why can't we get an option to use a news reader for these forums.
IMHO, Autodesk has a great setup for dual functionality forums(nntp & http).
[rant off]SolidworksGeneral
