I ran accross this for the first time today, and waswondering if anyone else has had this experience.
I have a an assembly model. The last thing in my tree is anassembly cut feature, where the assembly has 32 holes drilled thrueverything, so that an additional item can be bolted on in thefield.
I had placed a note on the drawing for the fabricator, indicatingthat the views depicted a right hand version (-001) and that a lefthand version was also needed (-002).
They refuse to manufacture -002 without a dedicated drawing...
so..this being an urgent project...I fired up SW, and got busy...
I was able to mirror "components", but I couldn't figure out anyway of mirroring the assembly cut feature. This is a real problemfor us.
Am I being thick skulled ? Is there a way to do this? Is there aknown work around? Do we need to issue an enhancement request?
I very much appreciate any feed back or suggestions.
Thanks !
Greg Van Arsdale
SW 2008 sp 3.1
XP Pro 2002 sp2
Pentium 4, 3.4 GH, 2 GB RAM
nVIDIA Quadro FX 3400
SolidworksAssemblies
I have a an assembly model. The last thing in my tree is anassembly cut feature, where the assembly has 32 holes drilled thrueverything, so that an additional item can be bolted on in thefield.
I had placed a note on the drawing for the fabricator, indicatingthat the views depicted a right hand version (-001) and that a lefthand version was also needed (-002).
They refuse to manufacture -002 without a dedicated drawing...
so..this being an urgent project...I fired up SW, and got busy...
I was able to mirror "components", but I couldn't figure out anyway of mirroring the assembly cut feature. This is a real problemfor us.
Am I being thick skulled ? Is there a way to do this? Is there aknown work around? Do we need to issue an enhancement request?
I very much appreciate any feed back or suggestions.
Thanks !
Greg Van Arsdale
SW 2008 sp 3.1
XP Pro 2002 sp2
Pentium 4, 3.4 GH, 2 GB RAM
nVIDIA Quadro FX 3400
SolidworksAssemblies