Hi
I am using Sw2009 sp2 (64 bit).
I made a lofted sheet metal part of a simple 90deg pressing (lookslike an angle)and when I placed the flat pattern view on thedrawing is was not flat. At the part, when I right click and exportthe flat pattern, the dxf file is not flat. It just looks like anormal end view in both cases.
It will flatten at part level though. So it's only in drawing viewand dxf export.
Anyone seen this?
Cheers
SteveSolidworksSheet Metal
I am using Sw2009 sp2 (64 bit).
I made a lofted sheet metal part of a simple 90deg pressing (lookslike an angle)and when I placed the flat pattern view on thedrawing is was not flat. At the part, when I right click and exportthe flat pattern, the dxf file is not flat. It just looks like anormal end view in both cases.
It will flatten at part level though. So it's only in drawing viewand dxf export.
Anyone seen this?
Cheers
SteveSolidworksSheet Metal