Hello,

I'm using SW2009 with Simulation cause I need to perform someanalysis in order to see how leaf springs will act/deform when itmove along being compressed by two rotating cylinders.

See this example for better understanding:





Is it possible to simulate this procedure?
I've already try to perform some studies without moving the leaf,only make pressur at it with the top cylinder (bottom cylinder wasfixed), but I'm not getting results, and it tell me that I have tomuch displacements or it don't find any solution.

Can, give me some tips to do that?

Tanks in advance and sorry my English! (I'm from Portugal)

Regards

Filipe
SolidworksSimulation