I created a new assembly, clicked "layout" from thecommandmanager, sketched several entities, and created severalblocks. I then selected an arc entity of a block (intended tobe acam), went into tools - sketch tools - and "makepath" wasunavailable! I also noticed belt/chain wasunavailable....
is this a setting on my end, fault in process, or a lackinthe software?
I also noticed in layout ellipses and polygons areunavailable... Ihad to create a new part, sketch the entities, makeblocks, andthen insert them into the layout...
Has anyone made blocks and then made paths or belts/chainsfrom theblocks in an assembly layout?
thanks for your time; it is appreciated!!!SolidworksAssemblies







is this a setting on my end, fault in process, or a lackinthe software?
I also noticed in layout ellipses and polygons areunavailable... Ihad to create a new part, sketch the entities, makeblocks, andthen insert them into the layout...
Has anyone made blocks and then made paths or belts/chainsfrom theblocks in an assembly layout?
thanks for your time; it is appreciated!!!SolidworksAssemblies