Hello SW users,
I'm in the process of setting up gauge table within SW to match ourfabricator's bend results. I was wondering if I'm able to create adrop-down list of different but yet common K-factors to use. Verymuch like the selection of different gauge material in the featuremanager. I used the same principle of seperating each numericalvalue by ";", however I had no luck.
Anyone have a solution?SolidworksSheet Metal
I'm in the process of setting up gauge table within SW to match ourfabricator's bend results. I was wondering if I'm able to create adrop-down list of different but yet common K-factors to use. Verymuch like the selection of different gauge material in the featuremanager. I used the same principle of seperating each numericalvalue by ";", however I had no luck.
Anyone have a solution?SolidworksSheet Metal
