In SW07 I could do this and I'm not sure if it was a settingor if it has been removed for some reason:
I would have an exploded view of an assembly on sheet 1 of thedrawing. I go to sheet 2, bring up the "model view" dialog toinsert a part, go back to sheet 1, click the part that I want toinsert, and when I clicked on the part it would automatically takeme back to sheet 2 to place the view of that part.
In SW08, I get to the point where I bring up the model view dialog,but when I go back over to sheet 1, the cursor goes back to itsdefault state and exits the model view dialog I had open in sheet2.
Is there a setting that toggles this, or is it a feature thatdisappeared in SW08?SolidworksDrawings And Detailing
I would have an exploded view of an assembly on sheet 1 of thedrawing. I go to sheet 2, bring up the "model view" dialog toinsert a part, go back to sheet 1, click the part that I want toinsert, and when I clicked on the part it would automatically takeme back to sheet 2 to place the view of that part.
In SW08, I get to the point where I bring up the model view dialog,but when I go back over to sheet 1, the cursor goes back to itsdefault state and exits the model view dialog I had open in sheet2.
Is there a setting that toggles this, or is it a feature thatdisappeared in SW08?SolidworksDrawings And Detailing
