Hello to all,
in the Parameters of CPoint, I find "Stub Length", to what serves(Help little clearly)? Moreover how I can set "Specification FieldName" and "Specification value" through design table ?
I have tried to change the values also in those standards of SW,but nothing.
Then why the infinite configurations in their rows are compiled ?
How they have made ?
Creating the table given automatically I find in CPoint1:Angle@CPoint1, Width@CPoint1, Depth@CPoint1, at the close of thetable exit the error that the values of such parameters are notvalid.
I try to set in excel like on the quota "1e-007", but nothing.
Moreover to what they serve, I do not find documentation to care.
Thanks,
AlessandroSolidworksRouting
in the Parameters of CPoint, I find "Stub Length", to what serves(Help little clearly)? Moreover how I can set "Specification FieldName" and "Specification value" through design table ?
I have tried to change the values also in those standards of SW,but nothing.
Then why the infinite configurations in their rows are compiled ?
How they have made ?
Creating the table given automatically I find in CPoint1:Angle@CPoint1, Width@CPoint1, Depth@CPoint1, at the close of thetable exit the error that the values of such parameters are notvalid.
I try to set in excel like on the quota "1e-007", but nothing.
Moreover to what they serve, I do not find documentation to care.
Thanks,
AlessandroSolidworksRouting
