When creating a new part from a template the Highestdeviation available is 0.1506mm. If I create a 3mm circle on asketch and extrude it - then look at the deviation again themaximum has dropped to 0.0064mm quite a bit lower.
In previous releases of SolidWorks this was able to be set at aconstant rate and the value didn't change after a feature wascreated. Also the value was able to be set at a much lower maximumvalue in the part / assembly template (lower than 0.1506mm)
Does any one know why this value can't be set lower on the templateand have it remain a constant when a feature is created?SolidworksAdministration
In previous releases of SolidWorks this was able to be set at aconstant rate and the value didn't change after a feature wascreated. Also the value was able to be set at a much lower maximumvalue in the part / assembly template (lower than 0.1506mm)
Does any one know why this value can't be set lower on the templateand have it remain a constant when a feature is created?SolidworksAdministration