We are running SW2008 SP5 and SW2009 SP1, and cannot modelflow through some of our more complicated parts and assemblies withXP and 2GB IBM single core workstations.
Because of some in-house advantages, we have a line on a 24 core (4x six core Xeon) 32GB machine. My information says Vista (and XP)won't run more than two sockets, so I have to go to Server.
Since Server 2008 is on the same kernal as Vista 64, we thought wecould run our flow simulations on this machine via the "Run at:"option.
Any tribal knowledge here that says don't bother? My risk here ismostly wasted time if this does not work.
Bob
SolidworksAdministration
Because of some in-house advantages, we have a line on a 24 core (4x six core Xeon) 32GB machine. My information says Vista (and XP)won't run more than two sockets, so I have to go to Server.
Since Server 2008 is on the same kernal as Vista 64, we thought wecould run our flow simulations on this machine via the "Run at:"option.
Any tribal knowledge here that says don't bother? My risk here ismostly wasted time if this does not work.
Bob
SolidworksAdministration