HOLE WIZARD UNITS


Hi all,

This is a repeat question that I did not find an answer to. Iapologize if someone
posted it else where. I have been importing ACIS (.SAT) files fromCadkey.
I do feature recognition and everything works well. The onlyproblem is that
the hole definitions are all metric (m6 clearance hole) etc. Ihave to manually
change the holes to the ansi hole specification. I've lookedeverywhere to
change the units but cannot get it to change. All the dimensionsbetween features are shown in inches when I use measure. Anythoughts would be appreciated.

Thanks,
RobSolidworksParts And Features