Hello to all,
I'm using a hole table for a table top, I have a mixture of holetypes.
Here we normally call out our reamed holes with a SYM. TOL. andeverything is working OK my dimension does not change.
After I load the print into our wault the dimension where I haveadded a SYM. TOL. changes insted of the dimension I now have the"1If" and the TOL.
Questian is how can I get my dimension back?
Thanks in advance,
Kurt JensenSolidworksDrawings And Detailing
I'm using a hole table for a table top, I have a mixture of holetypes.
Here we normally call out our reamed holes with a SYM. TOL. andeverything is working OK my dimension does not change.
After I load the print into our wault the dimension where I haveadded a SYM. TOL. changes insted of the dimension I now have the"1If" and the TOL.
Questian is how can I get my dimension back?
Thanks in advance,
Kurt JensenSolidworksDrawings And Detailing