Hole Table Question

I think I asked this question back in SW05, or 06, but heregoes again.

I have created a hole table. The table consists of roughly a dozenCounterbored holes, and a couple of dowel holes. The tolerance forthe dowel hole size came in just fine. The table properties is setto show hole location at three decimal place precision. I need toshow the dowel hole location at four decimal place precision, andwith limit tolerance.

Is there a way to over ride the location precision for those cellsdescribing the dowel hole locations? What about the need fortolerancing the X/Y location? Can that be done in the table?

I know I can export to AwfulCad and edit the table there, but thatisn't my favorite option.SolidworksDrawings And Detailing