Hi,
SW used to highlight a surface or a edge or point when me mousemarker went over it
So i could see what i would select.
After installing SW 2009 it was gone and i cant seem to find theoption in the settings.
i probably look over it,
could someone tell me where to find this option?
SolidworksGeneral
SW used to highlight a surface or a edge or point when me mousemarker went over it
So i could see what i would select.
After installing SW 2009 it was gone and i cant seem to find theoption in the settings.
i probably look over it,
could someone tell me where to find this option?
SolidworksGeneral