Flattening a Cable With A Connector & Back Shell

I have a question pertaining to flattening a cable route. SoI have a cable with a back shell and connector on each end. Oneback shell is straight the other is 90 degrees. So I haveconnection points on the connectors obviously in order to make myroute. But when I flatten it, only the cable and the connectorshows up in the flattened state. Now I know that the back shelloriginally had no affiliation with the route so that's why itwasn't showing up. So I tried making it affiliated with the route.I tried putting sketches in the back shells and convertingentities, I tried adding routing points. But still it will not showup in the flattened state. I've attached a zip file in this postwith a few ways that I have tried without any success. Maybesomeone here can enlighten me. Also one more question. One of theconnectors was made as an assembly, because it has a nut on it. IfI pull that assembly in it doesn't automatically start a route asif it would if it where a part. Is that normal?

Any help or advice from some routing guru's or possibly even anexample would be greatly appreciated.

Specs:

Windows XP 64bit SP2
SolidWorks 2009 64bit SP3.0SolidworksRouting