Has anyone come across this? Can't seem to figure out theproblem.
A drawing was created showing the flat pattern for a part, alongwith a few formed views. The drawing is checked into the vault. Alittle while later a revision needs to be made to the part, so ischecked out. Once the drawing opens, there is an error what come upsaying the "DefaultSM-FLAT-PATTERN" cannot be found for view1 andit will use the "Default" configuration. The flat pattern is goneand displays a formed view. I can select to show the flat patternagain, but I must re-dimension the flat pattern.
Just wondering if anyone know what happens there. This has happeneda few times now.
Thanks,
Paul.
SolidworksDrawings And Detailing
A drawing was created showing the flat pattern for a part, alongwith a few formed views. The drawing is checked into the vault. Alittle while later a revision needs to be made to the part, so ischecked out. Once the drawing opens, there is an error what come upsaying the "DefaultSM-FLAT-PATTERN" cannot be found for view1 andit will use the "Default" configuration. The flat pattern is goneand displays a formed view. I can select to show the flat patternagain, but I must re-dimension the flat pattern.
Just wondering if anyone know what happens there. This has happeneda few times now.
Thanks,
Paul.
SolidworksDrawings And Detailing
