I'm new to solidworks.
So what i have is a linear bolt pattern(tapped holes) on a weldmentand want to match this same pattern to the bolt on cover (thruholes). What is the best way to sync these up, without having to dothe hole pattern set-up again on the cover part?
Thanks
SolidworksAssemblies
So what i have is a linear bolt pattern(tapped holes) on a weldmentand want to match this same pattern to the bolt on cover (thruholes). What is the best way to sync these up, without having to dothe hole pattern set-up again on the cover part?
Thanks
SolidworksAssemblies