I admit, I was really looking forward to the FilletXpertstuff in 2008. The cornerXpert looked like it might be useful, andI was really excited about the new edge selection options.
I've been working on a part that I've already completed for acustomer, and so I knew what the fillet scheme had to look like. Itwas just a bullet shaped area on a complex surface of a part raisedup slightly to give you some grip with your fingers.
I tried to use the FilletXpert for selection, but it takes so long,could use a couple of additional options, and certainly could usethe ability to ctrl-select selection sets. Mainly, it is just tooslow, and I find that I'm better off with window selecting stuff bythe time I'm done trying to get the automated options to do exactlywhat I want.
Is anyone else using these options in anything other than canneddemos?SolidworksParts And Features






I've been working on a part that I've already completed for acustomer, and so I knew what the fillet scheme had to look like. Itwas just a bullet shaped area on a complex surface of a part raisedup slightly to give you some grip with your fingers.
I tried to use the FilletXpert for selection, but it takes so long,could use a couple of additional options, and certainly could usethe ability to ctrl-select selection sets. Mainly, it is just tooslow, and I find that I'm better off with window selecting stuff bythe time I'm done trying to get the automated options to do exactlywhat I want.
Is anyone else using these options in anything other than canneddemos?SolidworksParts And Features