This is perhaps a strange question, but I shall ask itnonetheless.
It is possible to add something to the "feature" tree which is nota feature?
We, like most companies I suspect, have a good deal of mirroredparts. With the mirrored part you can see from the feature tree theoriginal handed part as it were; you cannot from the original partsee that a mirror has already been created.
It would be nice to be able to add something obvious, where theuser can readily see it (ie the feature tree) something whichindicates that a mirror of that part exists.
Slightly out of the box idea but would welcome ideas suggestionshow other people deal with this.
Thanks
SolidworksApi macros
It is possible to add something to the "feature" tree which is nota feature?
We, like most companies I suspect, have a good deal of mirroredparts. With the mirrored part you can see from the feature tree theoriginal handed part as it were; you cannot from the original partsee that a mirror has already been created.
It would be nice to be able to add something obvious, where theuser can readily see it (ie the feature tree) something whichindicates that a mirror of that part exists.
Slightly out of the box idea but would welcome ideas suggestionshow other people deal with this.
Thanks
SolidworksApi macros
