Hello,
please forgive me if this has been noted before, I searchedarounda bit and found nothing on this. Perhaps it is just me, Buthere goes, When exporting as an Adobe document form SW 07i havenoted that if a part has two configurations then thatswhatyou export. For example i have two configs of the same part, aLHand a RH. I have two Prints, a LH and a RH.whenexporting either to adobe i get the full config when i open thepdffile. is there a work around?
thanks in advance
markSolidworksImport export
please forgive me if this has been noted before, I searchedarounda bit and found nothing on this. Perhaps it is just me, Buthere goes, When exporting as an Adobe document form SW 07i havenoted that if a part has two configurations then thatswhatyou export. For example i have two configs of the same part, aLHand a RH. I have two Prints, a LH and a RH.whenexporting either to adobe i get the full config when i open thepdffile. is there a work around?
thanks in advance
markSolidworksImport export