I am getting really frustrated with this analysis run. Afterhaving trouble getting it to mesh properly, I then had problemsgetting my restraints set properly, now I apparentlly have amessage:
"Element volume smaller than minimum 1.0e-25"
or something clost to that. If you click OK, you then get kickedout with an analysis failed pop-up, then back to SW to start allover again...
What causes this? I am coming into using CW08 now that I am tryingout the 08 releases. Before we didn't spend much time with runningstudies (read that as one or maybe twice in 3 years so far). I amtrying to get a handle on this process but our products are/havebeen incompatible with CW up until recently as far as I could tell.Or at least not without some significant knowledge of thesoftware.SolidworksSimulation
"Element volume smaller than minimum 1.0e-25"
or something clost to that. If you click OK, you then get kickedout with an analysis failed pop-up, then back to SW to start allover again...
What causes this? I am coming into using CW08 now that I am tryingout the 08 releases. Before we didn't spend much time with runningstudies (read that as one or maybe twice in 3 years so far). I amtrying to get a handle on this process but our products are/havebeen incompatible with CW up until recently as far as I could tell.Or at least not without some significant knowledge of thesoftware.SolidworksSimulation
