Hi Guys,
Is there a procedure to directly access explode lines? I know youcan first invoke the command to draw them and could, say, useSendKeys to escape or enter to edit mode; but I'm trying todecipher what exactly makes an explode line unselectable withoutthe extra steps. Is it on a layer? Does it have some specialproperty that makes it visible, but not touchable?
Any information would be helpful. Have written an app to do somesimulations and see that being able to draw a line or spline thatis not considered a 3D sketch by SW interface would be useful, andwould be consistent with the practices used in programs likeFloWorks.
Thanks,
DanielleSolidworksApi macros
Is there a procedure to directly access explode lines? I know youcan first invoke the command to draw them and could, say, useSendKeys to escape or enter to edit mode; but I'm trying todecipher what exactly makes an explode line unselectable withoutthe extra steps. Is it on a layer? Does it have some specialproperty that makes it visible, but not touchable?
Any information would be helpful. Have written an app to do somesimulations and see that being able to draw a line or spline thatis not considered a 3D sketch by SW interface would be useful, andwould be consistent with the practices used in programs likeFloWorks.
Thanks,
DanielleSolidworksApi macros