I ran into a big problem after I updated a bunch of drawings toSW2009. When these drawings were in SW2008 they had the draftstandard set at ANSI, all of the linear dim were .001 and angleswere .1. Nothing special just the default. When these drawing wereconverted to SW2009 the dimension precision changed, and the linearwhen to .01, and the angles went to .01. They are still set at theANSI standard but the precision has changed

My first question is, has anyone else having this problem? Nextquestion is does anyone have a macro that I can run on these filesto fix it?

Any help would be appreciated!!!SolidworksDrawings And Detailing