I am createing a drawing from a model of a plastic part.There is a vertical tapered wall that meets a wall perpindicular toit. The corner where the 2 meet has a radius/blend (it is acircular o-ring groove) . The moder wants a dimension to the radiuswhich is small (.25 millimeters to break sharp edges.) How do Idimension it?
1)dimension to the theoretical intersection of the 2 walls (withthe radius shown)which means I would have to draw extension linesfrom both surfaces to show the intersection point.
2) Remove all radii that are shown for breaking sharp edges(minimal radii) from the model?
3) Dimension to the center point of the critical radii?
Thanks in advance for your feedback!SolidworksGeneral
1)dimension to the theoretical intersection of the 2 walls (withthe radius shown)which means I would have to draw extension linesfrom both surfaces to show the intersection point.
2) Remove all radii that are shown for breaking sharp edges(minimal radii) from the model?
3) Dimension to the center point of the critical radii?
Thanks in advance for your feedback!SolidworksGeneral