Dimensioning Molded Parts & Draft Angle Conventions

I have just started a new job at a company that does a lotofinjection molded parts.  Coming from the aircraft industry,Iam far more familiar with parts that are machined aluminum asthelast company I worked at had small quantities of largerassembliesthat used dissimilar parts.  

I am curious if there is any place I can go to find outtheconventions for detailing the the following in regard toinjectionmolded parts:

1.  Which edge to dimension - maximum material edge ofafeature with draft, or minimum material edge?  

2.  Any standard notes which dictate convention utilizedtoaccomplish the above method of dimensioning.

3.  Example drawings and/or ASME publications relatingto thedetailing of molds and molded parts.


Thanks,


JasonSolidworksDrawings And Detailing