One of our drawing checkers is trying to make use of theDesign Checker tool in SW 2008 SP5.0. He setup the criteria andwhen attempting to perform a check on a drawing the Task Pane tabfor DC comes in blank and the graphics for it arent refreshing. Sowhatever was displayed previously; i.e. the SolidWorks Resourcestab or any other, is displayed in the DC tab. If I switch to adifferent tab and then try to activate the DC tab the graphicsstill do not refresh. Same goes with minimizing the Task Pane andthen bringing it back out.
Has anybody else seen this behavior? I was originally leaningtowards the graphics card/driver but everything else works justfine, it seems as if the tool is hanging up.SolidworksDesign Checker
Has anybody else seen this behavior? I was originally leaningtowards the graphics card/driver but everything else works justfine, it seems as if the tool is hanging up.SolidworksDesign Checker