How does one go about creating more than one hole of aspecified size on a sheet metal part?
Example: I want four (4) holes of .5" with one in each corneroffset by 1" x 1" and one (1) hole in the "middle" of the face. Canthis be done with 1 command, or must I use the hole commandmultiple times? How do I add both vertical and horizontalconstraints on the four (4) holes so that one (1) hole isdimensioned as suggested above, yet all four (4) holes are theexact same distance from the face corners?
Any tips, suggestions or errata are most welcomed!
SolidworksSheet Metal
Example: I want four (4) holes of .5" with one in each corneroffset by 1" x 1" and one (1) hole in the "middle" of the face. Canthis be done with 1 command, or must I use the hole commandmultiple times? How do I add both vertical and horizontalconstraints on the four (4) holes so that one (1) hole isdimensioned as suggested above, yet all four (4) holes are theexact same distance from the face corners?
Any tips, suggestions or errata are most welcomed!
SolidworksSheet Metal