Crash (?)!

I recently had 2008 installed. The project Iamworking on was sent to me by a designer earlier thisyear(April/May). We have a directory where we keep a read-only setofparts. Yesterday I went to open the assembly (tried 2-3 times)andhad SolidWorks kick me out completely. I have triedrollingforward/not rolling forward, rebuilding now/not rebuildingnow butto no avail. Any thoughts or suggestions as to why this maybeoccurring? Should I go back to each and every part and makesure2008 hasn't flip a vector in a chamfer or some of the thingsthat Ihave seen 2008 do? Again, the directory is read-only, so Iknowthat nothing has changed from that stand point from a few weeksagoexcept that I can't open up the assembly now. Thanks, Dale

SolidworksAdministration