I have a question about simulating a joint w/o connectorhardware parts in the assembly. The pivot end of a cylinderassembly is mated axis-to-axis with the the bushings in the armsub-assembly. Using ComosMotion, how can the joint be properlyconstrained without adding a SW connector part in the mainassembly?
In CosmosWorks for FEA, an option exists to add a connector pin orbolt to an assembly (w/o inserting a SW part file). How is thisdone using ComosMotion 2007? I have not yet decided what type ofconnector hardware to use for this joint (shoulder bolt, pin, etc.)and would like to run the simulation without adding extra parts.
SolidworksMotion Studies
In CosmosWorks for FEA, an option exists to add a connector pin orbolt to an assembly (w/o inserting a SW part file). How is thisdone using ComosMotion 2007? I have not yet decided what type ofconnector hardware to use for this joint (shoulder bolt, pin, etc.)and would like to run the simulation without adding extra parts.
SolidworksMotion Studies