Component Orientation Electrical

I'm new to using routing. I have created cable/wire libraryand am building a component library.
Here's my problem. When I drag and drop connectors into an assemblyto create a wire route subassembly, I can't orient the connector inthe direction I need.
An error message states that the position is defined. It appearsthat the connector is fixed in the orientation it was created.
The only mate references I've put on them are "Concentric" and"Mate Face".
I think I should still be able to rotate the component. Shouldn'tI?

I'm sure I'm missing one piece of the puzzle here.SolidworksRouting