I have a part that will be mirrored. The part line is createdon three sides or faces (three sketches) and joined by a compositecurve. As the surface to create the parting line is sweep, a3DSketch was used to add corner rounds to the converted compositecurve (match outside radius of solid body).
What is the best recommend technique for creating this parting lineas drafted surfaces need to be created? The split line is alsopresent on the inside of the shell, but does not need to be on theinside as that surface is already drafted. The mounting feature fora latch was added after the shell, and I would like it to gopositive 1 deg above the split line, and negative 1 deg below thesplit line where the mold tooling faces will meet.
What is the recommended best practice technique for creating thedrafted surfaces and parting lines?
Chris
SolidWorks Office Premium 2009SolidworksPlastics And Mold Design
What is the best recommend technique for creating this parting lineas drafted surfaces need to be created? The split line is alsopresent on the inside of the shell, but does not need to be on theinside as that surface is already drafted. The mounting feature fora latch was added after the shell, and I would like it to gopositive 1 deg above the split line, and negative 1 deg below thesplit line where the mold tooling faces will meet.
What is the recommended best practice technique for creating thedrafted surfaces and parting lines?
Chris
SolidWorks Office Premium 2009SolidworksPlastics And Mold Design
