1 - During opening of assembly I get message:
"The size of toolbox component (part name) referenced by thisassembly was not found. Would you like toolbox to automaticallycreate the missing size?"
2 - I confirm and open the assembly
3 - When I try to check-in the assembly into the PDMWorkgroup vaultI get another message:
"Unable to write custom properties to the file "part name".Please make sure that the file is not being used by anotherprogram"
4 - After that the check-in process is interrupted and the assemblyis NOT checked into the vault.
The parts I am getting problems with are some toolbox parts.
Has anybody got similar problem and found a solution to it?
ciao
Marco
SolidworksWorkgroup Pdm
"The size of toolbox component (part name) referenced by thisassembly was not found. Would you like toolbox to automaticallycreate the missing size?"
2 - I confirm and open the assembly
3 - When I try to check-in the assembly into the PDMWorkgroup vaultI get another message:
"Unable to write custom properties to the file "part name".Please make sure that the file is not being used by anotherprogram"
4 - After that the check-in process is interrupted and the assemblyis NOT checked into the vault.
The parts I am getting problems with are some toolbox parts.
Has anybody got similar problem and found a solution to it?
ciao
Marco
SolidworksWorkgroup Pdm
