Does anyone know of a way to edit the Installation Manageradmin image options after an image is created? I suppose I couldjust edit the AdminDirector.XML file, but I'd rather go through theIM interface again if I could.
I am testing SW2008. The options I am concerned about is thetoolbox location and whether the installation is new or an upgrade.When I am ready to release 2008 on everyone else here I want tojust change the toolbox location from a temporary location to thefinal location. The new vs. upgrade option comes up because I wantto figure out and test the new service pack upgrade process(asdiscussed here) using SP0 and SP1.1. The options I would choosenow don't necessarily correspond to that of someone lateron.SolidworksAdministration
I am testing SW2008. The options I am concerned about is thetoolbox location and whether the installation is new or an upgrade.When I am ready to release 2008 on everyone else here I want tojust change the toolbox location from a temporary location to thefinal location. The new vs. upgrade option comes up because I wantto figure out and test the new service pack upgrade process(asdiscussed here) using SP0 and SP1.1. The options I would choosenow don't necessarily correspond to that of someone lateron.SolidworksAdministration