Using nearly exclusively the top-down method we have lots ofsketches and we make lots of changes in them. So every measurewhich makes edition easier is highly welcome.
Until SW 2008 SP 1.0 there was a nice feature: as I double-clickedon any entity of a sketch in the graphics area the relevant sketchhad been opened for edition. After finishing editiondouble-clicking into an empty area of the graphics screen closedthe part.
Now I can't open a sketch by double-clicking on any entity of it(the closing function still works, although this is problematicbecause of other reasons). Has this feature been eliminated or am Imissing something here?
Regards:
JohnSolidworksUser Interface
Until SW 2008 SP 1.0 there was a nice feature: as I double-clickedon any entity of a sketch in the graphics area the relevant sketchhad been opened for edition. After finishing editiondouble-clicking into an empty area of the graphics screen closedthe part.
Now I can't open a sketch by double-clicking on any entity of it(the closing function still works, although this is problematicbecause of other reasons). Has this feature been eliminated or am Imissing something here?
Regards:
JohnSolidworksUser Interface
