I teach CAD as part of a robotics class, and am havingtrouble finishing out a project I would like the class to do. Weare creating a rudder for a sailboat, with an NACA0012 airfoilsection. We've put the outline of the rudder on the right plane andput the airfoil sketches on a sequence of planes offset from thefront plane. We can loft among the sections, but cannot figure outa way to complete the loft on the left side of the part so that itsmoothly merges with the outline spline on the right plane.Attached is the part. Other than putting another tiny airfoilsection on a plane very near the tip, is there a better way?
Thanks,
John ClaytonSolidworksSurfacing