Alternate gates move by dragging

OK, I can't find the original thread as I suspect that it has been deleted.

However, someone had a lever that they wanted use as an actuator to alternately actuate two shafts.  And they wanted to actuate it with mates and with dragging the lever.

I think that I figured it out. I have attached a video.

In addition, I have attached my assembly.

I know that there is a way to make this more robust, but I ran out of time to spend on this.  Maybe someone can look at it and improve on it.

EDIT:  Wanted to add that this was done with SW 2015 SP5

Message was edited by: Dan Pihlaja

SolidworksAssemblies