Hello guys,
I have simulate a pipe is getting radial force from the inside by a component with teeth as figure below.
But Seems from simulation above still not accurate due there is a point where the result of VME Stress is very high (on one teeth but other teeth are having normal VME stress).
May you give me advise on this, probably my interaction is wrong (due in solidwork 2021 has may update and i still confused on these).
Below is my interaction, the simulation should be using Contact.
Before many thanks,
Regards.
As part of the migration from the legacy Forum to the new SOLIDWORKS Forum, there was an overlap in timing where the new Forum was being loaded with historical data from an export migration, while at the same time, the legacy Forum was still operating during the period of March 12th to March 31st. Due to the overlapping timelines and import-export technical issues, posts during that time-frame could not have their media imported. If you created a post in the legacy Forum during that time-frame and wish to update the post in the new Forum with supporting media, please go to your post in the new Forum, enter into Edit mode and re-add any supporting media you want to insert.
The easiest way to find your posted content is: from the new Forum, click on your profile icon in the top right of the GUI, then select "My Profile" and you will be taken to the "Overview" tab where you can see all of your posting history.
Thank you