I have some custom 3" & 5" piping that will be formed.Our vendor would like the coordinates of the virtual sharps. Isthere an easy way that this can be obtained that is parametric thatI can reference either in a table or some type of callout at eachpoint?
My first attempt was to create center lines on each axis to eachsharp and dimension them. Then I created a property for each X, Y& Z for every sharp and link the property to the dimension.Needless to say this is quite time consuming and could easily gettrashed if not very careful. Any ideas on how I can achievesomething like this? I can upload examples if it would help of whatI have done if it helps.SolidworksGeneral
My first attempt was to create center lines on each axis to eachsharp and dimension them. Then I created a property for each X, Y& Z for every sharp and link the property to the dimension.Needless to say this is quite time consuming and could easily gettrashed if not very careful. Any ideas on how I can achievesomething like this? I can upload examples if it would help of whatI have done if it helps.SolidworksGeneral